Go Greener Tips

Installing a tubular skylight is a reasonably simple venture for the first time do-it-yourselfer, but once in a while the instructions get lost after which you might not know where to start. Here’s a instrument checklist and step by step instructions on methods to install a photo voltaic tube light.

Device Record

- Claw Hammer
- Pry Bar
- Plumb & String
- Jigsaw
- Drill & Bits
- Screwdrivers
- Caulking Gun
- Drywall Saw
- Tin Snips
- Utility Knife

Step 1

Resolve the place you want the light from inside the room. Drive a nail up into the attic to mark the spot. Climb up into the attic and discover that nail. Be sure that the diameter of the solar tube light is not going to run into a rafter and is free of wiring.

Step 2

Now, it is time to mark the spot on your roof. Drop the plumb from its string till is is directly over the nail developing from the ceiling the place the sunshine goes. Mark this spot by driving a nail up and through your roof.

Step three

Your new mild came with a template that can assist you mark the finished holes to the best diameter. Take that template again down into the room that you are lighting. Pull the nail out. Insert it by the center gap of the template and back into the ceiling. Mark your hole and reduce that hole along with your drywall saw.

Step four

Time to go on the roof. Take the hole template with you. Discover that nail you drove by means of the roof. Heart the template on that nail and mark your diameter. Use the utility knife to cut shingles out of marked area. Be sure you take away all nails from the area, also. For those who drill a gap large sufficient fro the blade, you should use the jigsaw to cut the diameter through your roof.

Step 5

Apply the roof caulking that came with your new light tube around the diameter of the outlet you just cut. This will seal below the flashing to forestall leaks. Slide the flashing below all roofing supplies in the area and secure it to the roof with chrome steel screws. Apply the mud seal to the within prime of flashing.

Step 6

It’s worthwhile to figure out the size of light tube that you need. Put the light tubes together. Pull the protecting film down about 2 inches to clear the area where the adhesive will make contact. Take away the adhesive backing and overlap tubes. Press tubes together and secure with a sheet metal screws. Attach as many tubes as you need then apply the aluminum foil tape at each junction to seal them completely. Take your tube meeting up on the roof.

Step 7

Insert gentle tubes into the flashing, crimped end first. Tubing have to be flush with the trim ring in the room. Safe the tubes in place with a number of sheet metal screws(at the very least three). From the roof, trim any excess tubing with tin snips. Keep tubing as spherical as attainable to seal against the dust seal.

Step eight

Remove the protecting film from the tubing and install the dome assembly. Attach the assembly to the flashing with chrome steel screws. DO NOT APPLY ANY SILICONE AROUND DOME ASSEMBLY. THIS WILL CAUSE CONDENSATION INSIDE THE SKYLIGHT.

Step 9

Again inside, remove any protective film that you can see. Set up the ceiling deco-ring and light-weight diffuser. You are able to do that by aligning stand-offs with the keyholes and twisting clock wise. Now your all set, it is time to reap the rewards from installing a tubular skylight into what should now appear like a warm rich feeling home.

Learn how to save energy, you may visit this website: green diy energy, you may also read reviews for green diy energy or this green diy energy review article.