Go Greener Tips

Generating your own energy pellets with a residence pellet mill has a lot of appeal to some individuals. Owning your own house pellet mill can bring several advantages. Firstly you can create your own energy from the resources you have available to you. This maybe local sawdust, or even straws, grasses along with even cardboard in addition to paper. Producing your own fuel pellets cannot only bring a source of fuel independence, it can also generate some additional income. Most small house pellet mills manufacture around 100 kilograms an hour. Since most homes only use between 3000 along with 5000 kilograms in a year, even a small house pellet mill has the ability to produce much more than the owner would need. This brings some options, either the pellet mill could be a group buy between an collection of pellet users, or one person could create the pellets in addition to sell the pellets back into the local area.

Learn more about Home Pellet Mill

At PelHeat we provide a consultation service on pellet production apparatus, including some pellet mills suitable for residence use. To create good quality pellets, your raw material requires certain properties. First it must be in small particles of either 6mm or below. The raw matter must also be fairly dry. However some moisture is required for the pellet process to work. Finally to make consistent quality pellets, it is important to provide the pellet mill by consistent quality raw material. In this sense pellet production is much like cooking, as well as will take a few tries to get it right. To find out more please visit the PelHeat website. Producing wood pellets is not just always about only the pellet mill, it depends on what your raw materials is like. For instance if you wish to process logs into pellets there are more than a few stages of size reduction which must take place first. Firstly the log must go through a chipper. Once into chips, these must also be reduced in size, therefore the chips are then placed in a hammer mill.

Read more about Pellet Mill Manufacturers

Because of high speeds of the hammers impacting on the biomass chips, the chips shatter into small particles. A hammer mill has an internal screen, to confront oversized particles from escaping the hammer mill until a 6mm particle size is achieved. The particles are then take from the base of the hammer mill with a fan plus then separated from the air stream via a cyclone separator. The particles are now small enough for the pellet mill. However the particles must also be dry enough. There are several drying solutions used depending on the productivity required.
The two main drying solutions are flue dryers and rotary drum dryers. Smokestack dryers carry the wet particles in a hot air stream to remove moisture. Chimney dryers are a very cheap drying solution, though they cannot cope by high moisture content materials.

More information on Biomass Bioenergy